SYSTEM MATCHING GUIDE

Prepare the information needed for a matched set

The more clearly the system conditions are described, the faster a product family or model can be reviewed. Use the checklist below before sending an enquiry.

View the request route Send project information

REFERENCE ROUTEInformation → review → next stepSend the information you already have

MATCHING CHECKLIST

Use these fields to prepare the request

Not every project has every field. Send what is available and mark unknown items clearly so the review can start from the right question.

SYSTEM INPUT

Material and profile

Aluminium or uPVC, profile brand or series, groove or cross-section and any known interface.

Review profile fields

OPERATING INPUT

Opening or connection

Casement, tilt & turn, sliding, lift-slide, point-fixed, clamp or another operating direction.

Review opening fields

TECHNICAL INPUT

Weight and geometry

Sash or door leaf weight, glass thickness, dimensions, handing and installation position.

Review load fields

SUPPLY INPUT

Quantity and destination

Finish or colour, project quantity, destination country and target delivery timing.

Review supply fields

REFERENCE INPUT

Model and evidence

Existing model, catalogue page, drawing, product photo or site image for comparison.

Review evidence fields

FIELD-BY-FIELD REVIEW

What to include in the request

These fields are used to narrow the route. They are not a promise that one component is compatible with every system.

Profile or cross-section

Upload the profile drawing or photo, including groove dimensions when known.

Opening and handing

State the operating type, direction, handing and number of leaves where relevant.

Weight, glass and dimensions

Share sash or door weight, glass thickness, width, height and other key dimensions.

Finish, quantity and destination

Add finish or colour, project quantity, destination and target delivery timing.

Drawing or photo

Attach a model reference, product photo, project drawing or installation detail.

CONTINUE

When the fields are ready, submit the information for a technical and commercial review.

MATCHING REQUEST

Send the fields you already have

You do not need to know the exact model to start. A clear profile, opening direction, photo or project drawing is a useful first reference.

Product or system direction
Profile, drawing, photo or model
Quantity, destination and timing